Bending Tool with 3.0 Stylus Lower Part 3 mm x OD 6

3 mm x OD 6

0 mm for 3

Dimensions: OD 2

Offset from Lower Shaft: 1

It is recommended (not always necessary) to use the Flattening Drill prior to the Pilot Drill if the crest is sharp or slanted and start the dental implant osteotomy site preparation with the Pilot Drill

Bending Tool with 3.0 Stylus Lower Part 3 mm x OD 6Advantages, Protocol, and Purpose: Bending Tool Protocol The Bending Tool is designed for making single or multiple bends to Guide Right 2 Piece Guide Posts to accomplish angle corrections determined by an evaluation with a cone beam X ray. Pair with: Stylus Bending Plate Protractor 5 64" Hex Driver 0. 035" Hex Driver Relevant Presentations: 2 GRAFTS & REPLACEMENT OF LOWER INCISOR FABRICATION OF MAXILLARY DENTURE GUIDE CASE FOR CO AXIS ANGLED IMPLANTS