Wire Harness Rev. 2 Length:7.5" It does however come with

It does however come with the "Type 2" output cap which features the threaded shaft and barb fitting typically used with traditional TM spec receivers

This typically only happens if the system is run completely out of air so that the pressure drops below the operating range of the system

This switchboard is designed to replace the original trolley type trigger switch in a traditional TM spec V2 gearbox

Supports both priming (constant) and switched (trigger activated) modes of the box magazine

You are able to order the UGS™ for the VFC HK417 in two different configurations

Wire Harness Rev. 2 Length:7.5" It does however come withThe PolarStar wire harness is constructed with 24 AWG wire for superior continuity and features a nylon mesh sheath to protect the wires as they pass through the replica's body. These harnesses are universally compatible with all PolarStar electro pneumatic HPA systems excluding the original V2 GEN1 Fusion Engine and Amoeba kits. Compatible with any PolarStar system that uses a REV2 or REV3 FCU. 18" is standard length for V2 kits in F2, F1 and JACK.