USB-RLY16L(16 Low Power 8 channel relay outputs at 16A) [Discontinued] _MAKE_SENSOR_VOLT Requires: 2-AA (not included)

Requires: 2-AA (not included)

It can also be very complicated with the wire soldering and connections

2017 The board has been updated to change the USB-Serial converter chip to CP2104 and remove the SWD connector (you can get to the SWD connection pads on the bottom of the PCB)

Satellites: 33 tracking

pin interface and communication commands of this version（V5

USB-RLY16L(16 Low Power 8 channel relay outputs at 16A) [Discontinued] _MAKE_SENSOR_VOLT Requires: 2-AA (not included)A low power version of the USB RLY16 module, the USB RLY16L is powered solely from the USB bus and provides eight volt free contact relay outputs with a current rating of up to 16Amp each. The relays are SPCO (Single Pole Change Over) types and provide position 0, position 1 and common pins (latching relays and have no "normally open" or "normally closed" contacts) on the screw terminals labeled as 0, C and 1 accordingly. The relays will also retain