SoftServo-B10CH (Servo Controller/ RC Signal Generator) [Discontinued] _MAKE_SENSOR The Pi-EzConnect GPIO HAT lets

The Pi-EzConnect GPIO HAT lets you connect electronics to your Raspberry Pi using screw terminals

Arduino Leonardo or ATmega32u4 compatible - 12 analogue channels at 10-bit resolution

It can be applied in various fields: telepoint base stations

Width:19mm

3V regulator so you can use it with 5v logic such as an Arduino

SoftServo-B10CH (Servo Controller/ RC Signal Generator) [Discontinued] _MAKE_SENSOR The Pi-EzConnect GPIO HAT letsStrictly speaking, SoftServo B10CH is a 10 channel PWM signals generator, which can be applied to most of the devices that integrate RC interface, but the original intention of the design is to control the PWM Style servo. It integrates RS485 and I2C into one connector, and they share the same user register, so the servo controller can be used via any one of the two interfaces at any time. All functions can be performed by reading or writing the user