Maker HAT Base for Raspberry Pi 500/400 Brand_Espruino Mega and Leonardo

Mega and Leonardo

2024 - we've updated this PCB with Adafruit Pinguin to make a lovely and legible silkscreen - you may get the new PCB or the older version with vector fonts - both are identical other than the fancy silkscreen

gpio=14=op

Pi 2 or Model A+ / B+ (any Pi with a 2x20 connector)

The right graph above shows output currents at which the voltage regulator’s over-temperature protection typically kicks in after a few seconds

Maker HAT Base for Raspberry Pi 500/400 Brand_Espruino Mega and LeonardoThe Maker HAT Base extends out all of the Raspberry Pi 500 or Raspberry Pi 400 GPIO pins in a quick and simple way, which is super handy for using your favourite Raspberry Pi HAT or building your own simple circuit with jumper wires on the included mini breadboard. Since a ribbon cable is used for the connection, the Maker HAT Base is compatible with the Raspberry Pi 5, 4, 3 and Zero too. This is especially useful when the Raspberry Pi is enclosed in